Sharp Atomic Clock Spc373 User Manual __full__ -

: If the signal won't reach you, you can manually set the time by holding the M.SET or SET button until the hands start moving, then releasing it once you reach the correct time.

The Sharp SPC373 updates its internal timekeeping daily by listening for the WWVB radio signal.

Press and hold the button for 2 seconds. The alarm hour digits will begin flashing. Press UP or DOWN to select your desired alarm hour. sharp atomic clock spc373 user manual

Press the or DOWN buttons to set your desired alarm hour. Press ALARM SET again; the alarm minute digits will flash. Press the UP or DOWN buttons to set the alarm minutes. Press ALARM SET one final time to save your settings. Activating and Turning Off the Alarm

Master Your Time: The Ultimate Guide to the Sharp Atomic Clock SPC373 : If the signal won't reach you, you

Press the WAVE button (or "Search" button) to force the clock to search for the signal again.

Locate the DST switch on the back of the clock. Slide it to ON if your region observes Daylight Saving Time. Slide it to OFF if you live in an area that stays on Standard Time year-round (such as Arizona or Hawaii). The clock will automatically adjust its display forward or backward by one hour when the seasonal shift occurs. Alarm Clock Operation The alarm hour digits will begin flashing

Switch to OFF if you live in an area that does not observe DST (e.g., Arizona, parts of Indiana). 3. Signal Reception: Finding the Best Location

The WWVB radio signal is weak during the daytime and can be blocked by structural elements.

The clock features a built-in sensor that tracks ambient indoor temperature. To toggle between Fahrenheit (°F) and Celsius (°C), press the button located on the rear control panel. ⏰ 12/24 Hour Format