_hot_ - Gateman+v20+manual

Open your door before starting any programming to avoid accidentally locking yourself out. 1. Registering or Changing the Master PIN Code Your PIN code can be 4 to 12 digits long. Open the battery cover on the inside unit. Press the button once. (A beep will sound). Move to the outside unit and enter your new PIN Code . Press the [*] (star) button to finish. Test the code while the door is open. 2. Registering RFID Cards / Key Tags

For exact programming codes, check the sticker inside the battery cover – many V20 variants have a printed there.

as an emergency power supply by touching it to the external terminals on the front body. Burglar Alarm

The security code can range from . Setting a new code automatically overwrites any previous PIN code. manuel d'utilisation - gateman v10 / v20 - BT Security gateman+v20+manual

Touch the RFID cards you wish to register one by one against the card reader on the outer body. (You can register up to 20 cards). Press the button to finish.

, you must always start from the of the lock. Locate the battery cover, slide it off, and find the registration button labeled [R] (sometimes marked as a small round button near the batteries). 1. How to Change or Register the Master Password

: You can find a full copy of the Gateman V10-V20 Manuel on Archive.org. Open your door before starting any programming to

Fold excess cable neatly into the door cavity to prevent pinching.

Before starting installation or programming, verify that your package contains all necessary parts. Package Contents : Outer keypad and card reader interface.

Press the button on the main body, or turn the manual override thumbturn. Locking the Door Open the battery cover on the inside unit

While maintaining contact, touch the keypad, enter your PIN code, or scan your card to unlock the door. Replace the internal batteries immediately once inside. Troubleshooting Possible Cause Keypad does not light up. Batteries are dead or inserted incorrectly. Check battery orientation or use a 9V emergency battery. The lock emits a melody but won't open. Low battery voltage. Replace all 4 AA batteries with new alkaline ones. The lock jam alarm sounds. The lock bolt is catching on the strike plate.

: When enabled, the lock engages within 5 seconds of the door closing. Manual Unlocking (Inside) Manual Thumb Turn OPEN/CLOSE button on the interior body. External Unlocking

To prevent bystander spying or fingerprint thermal tracing on the keypad, Gateman utilizes a palm-touch mechanism. Always touch the screen with your open palm before and after entering your PIN code. This scatters fingerprint smudges across the entire screen, making it impossible for intruders to guess your digits. Unlocking from the Inside Simply press the on the indoor unit.

the * button or the registration button again to save. Registering Key Tags / RFID Cards You must register all tags at the exact same time. Press the I (or R ) registration button on the inside unit.

Most users ignore the interior DIP switches, but the manual details their power. To access them, remove the interior body cover.