Disco — 240 Dmx Controller Manual Updated

Adjust the to determine how long a step remains on screen before changing.

: 3-pin XLR output, LCD display (16x2 characters), and 8 manual channel faders with page switching. 2. Hardware Setup & Connection

Use the SCANNER buttons (P1-P12) to select which light(s) you want to control.

Buttons used to select which lighting units you want to control.

Note: Some fixtures use 5-pin XLR – adapters are available. disco 240 dmx controller manual

Ensure the fixture addresses match the controller allocation map exactly.

Use the Bank Up/Down buttons and Scene buttons (1–8) to find the first scene you want to add.

You likely forgot to add a 120 Ω terminator to the end of your DMX chain.

Press the BLACKOUT button to instantly shut off all lighting output. Troubleshooting & Setup Tips Adjust the to determine how long a step

Press and hold the Program button for roughly 3 seconds until the indicator LED flashes.

Repeat this workflow for up to 40 steps within the chosen chase. 3. Exiting and Saving

Move the controller further away from low-frequency subwoofers or turn down the audio source output volume.

Press Auto/Del and adjust speed/fade sliders to run pre-programmed chases. 6. Troubleshooting Hardware Setup & Connection Use the SCANNER buttons

These buttons store and trigger static lighting looks (scenes). You can save up to 8 scenes per bank. Bank Buttons (Up / Down)

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Understanding DMX - Sweetwater

: Determines how smoothly colors or positions blend together.

Understanding the physical layout of the Disco 240 is essential for fast programming. The console is divided into several control zones:

Press and hold the Program button for three seconds until the LED stops blinking. 4. Programming Chases

Once the stage look is complete, press the Midi/Add (or Insert/Add ) button. The LCD screen will flash, indicating the step has been logged.