Restart your computer to ensure the system registers the new driver files. Method 2: Manual Installation via Windows Device Manager
Once the software is installed, you need to verify that Windows recognizes your programming cable.
Modern versions of Windows require all hardware drivers to be digitally signed by Microsoft. Because some older or legacy Xinje USB drivers lack this digital signature, Windows may block the installation with an error stating "The third-party INF does not contain digital signature information."
You should see a clean listing under or Universal Serial Bus controllers (e.g., Xinje USB Device or a specific virtual COM port number like COM3 ). Step 6: Configure Software Communication Settings xinje plc usb driver install
Windows may block the driver because it lacks a digital signature.
A: Windows 11’s stricter USB stack is the culprit. Run the installer in Windows 8 compatibility mode (Right-click → Properties → Compatibility → Run this program for Windows 8).
Once extracted, you can find the raw driver files hidden within the software directory. Restart your computer to ensure the system registers
Go to .
(e.g., version V3.8.0). During the installation of XDPPro, the system will prompt you to install the USB driver XINJEConfig software automatically. XC Series: Download and install
Ensure your Windows user account has permission to install hardware drivers. Because some older or legacy Xinje USB drivers
Navigate to the directory where your Xinje programming software was installed. By default, the driver files are located in one of these paths:
Plug the programming cable (typically a USB-to-Round-Port cable or a standard USB-B/USB-C cable depending on the PLC port) into the PLC.
Before beginning the installation process, ensure you have the following components ready:
After successfully installing the driver, configure your software to communicate with the PLC. Configuration in XGPad (XD/XL Series) Open .